User manual

Switching on your TomTom Bandit

Press the START button at the back of the TomTom Bandit for 2 seconds to switch your TomTom

Bandit on. The TomTom logo is shown, and the red LEDs flash and you hear the start-up sound. If no

microSD card is inserted into the Batt-Stick, you are asked to insert a memory card so that the

TomTom Bandit can switch on.

If the TomTom Bandit is in standby mode, press the control button to wake up the TomTom Bandit.

The TomTom Bandit stays on during the following conditions:

 The TomTom Bandit is recording a video or you are taking photos.

 You are using the screen to set-up the TomTom Bandit.

 You are operating the TomTom Bandit from your mobile phone using Wi-Fi or Bluetooth.

Switching off your TomTom Bandit

Press the STOP button at the front of the TomTom Bandit for 2 seconds to switch it off. The red

LEDs flash and you hear the shut-down sound.

The TomTom Bandit will automatically shut down if the battery power becomes too low.

Standby

To save power the TomTom Bandit automatically switches to standby after a few minutes if it's not

being used.

You can wake up the TomTom Bandit by pressing the control button, using the remote control, or

using the Mobile app. If you press the START button, the TomTom Bandit will start recording or

taking photos, depending on the mode you have set.

The TomTom Bandit switches off after two hours in standby.

Recording

Your TomTom Bandit has separate START and STOP buttons, both on the TomTom Bandit and on the

remote control. Separate buttons make it easy to start recording, add video highlights and stop

recording because the function of the buttons is always the same.