Data Sheet

K019-CW43-DW datasheet_V1.6_15042020.doc | Shawn Xiao

requirements if applicable.

As long as all conditions above are met, further transmitter test will not be required.

However, the OEM integrator is still responsible for testing their end-product for any

additional compliance requirements required with this module installed.

IMPORTANT NOTE: In the event that these conditions can not be met (for example certain

laptop configurations or co-location with another transmitter), then the FCC authorization is no

longer considered valid and the FCC ID can not be used on the final product. In these

circumstances, the OEM integrator will be responsible for re-evaluating the end product

(including the transmitter) and obtaining a separate FCC authorization.

Manual Information To the End User:

The OEM integrator has to be aware not to provide information to the end user regarding how

to install or remove this RF module in the user’s manual of the end product which integrates

this module.

The end user manual shall include all required regulatory information/warning as show in this

manual.

OEM/Host manufacturer responsibilities

OEM/Host manufacturers are ultimately responsible for the compliance of the Host and

Module. The final product must be reassessed against all the essential requirements of the

FCC rule such as FCC Part 15 Subpart B before it can be placed on the US market. This

includes reassessing the transmitter module for compliance with the Radio and EMF essential

requirements of the FCC rules. This module must not be incorporated into any other device or

system without retesting for compliance as multi-radio and combined equipment

Industry Canada statement

This K019-CW43-DW complies with ISED’s licence-exempt RSSs. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired

operation.