User Manual

ManualsBrandsTonika Electronics Technology ManualsAudio EquipmentBluetooth Speaker

1. Connected the external Audio or Video/Audio Devices to the unit as previous procedures.

2. Slide the POWER ON/OFF Switch on the rear of unit to ON position to turn the unit to Standby

mode. The Power Indicator will light.

3. Press and hold the button on the unit or press the button on the Remote Control to turn on

the unit from Standby mode.

4. Press the SOURCE button on the unit or Remote Control to select input source as desire.

A. If FM (Radio) is selected, STANDBY/FM Indicator will blink:

i. Press the TUNE +/ button repeatedly to search and plays the next available FM station.

ii. Press the TUNE -/ button repeatedly to search and plays the previous available FM station.

iii. To searching the stations from begin. Press the RESET button on the Remote Control to

reset the radio to minimum frequency.

Notes:

The Antenna wire on the rear of unit is for radio reception. If reception is weak, unwound

and extended the wire or relocation the wire to improve the radio reception.

If a stereo FM station was searched, the unit will plays it in stereo mode automatically.

B. If AUX 1 is selected, the AUX 1 Indicator will light. Plays the music in the AUX 1 connected

Audio device as usual.

C. If AUX 2 is selected, the AUX 2 Indicator will light. Plays the video or music in the AUX 2

connected Video/Audio device as usual.

D. If BT (Blue Tooth) is selected, the Indicator will light and blinking. If this is the first time to use

BT or re-pairing the unit to a new BT device, pairing the unit to external BT device as bellows:

i. Power on the external BT device and enter to searching mode.

ii. Start pairing as the on screen instructions on the external BT device.

iii. After paired, the Indicator will stop blinking. (For details pairing procedures, please refer

to the user’s manual of your BT device.).

Notes:

When the external BT device searched the unit, our model number “CHT 941” will appears

on the display of external BT device.

Pairing code “0000” may need to enter.

Normal operation after paired:

i. Turn on the BT function of the external BT device.

ii. Power on the unit and selected the input source to BT as previous procedures.

iii. Wait a few seconds until the unit paired to the external BT device automatically. (The

Indicator will stop blinking).

iv. Plays the music in the paired BT device as usual.

5. Press the VOL (Volume) +/- buttons to adjust volume level.

6. Press the button on the remote control to turn off the sound temporary, press again to turn the

sound back.

7. Press the BASS +/- buttons on the remote control to enhance or reduce the bass level (low audio

frequency) as desire.

8. Press the TREBLE +/- buttons on the remote control to enhance or reduce the treble level (high

audio frequency) as desire.

9. When finished, press and hold the button on the unit or press the button on the Remote

Control to turn off (standby) the unit.

NOTE: If long period of time will not use the unit, power off the unit by slide the POWER Switch

to OFF position or unplug the AC/DC Adaptor from the unit and wall outlet.

OPERATIONS:

iv. Plays the music in the paired BT device as usual.