Use And Care Manual

8
MAINTENANCE
REPLACING SAW BLADE
1. When replacing the saw blade,make
sure the new saw blade has a diameter
of 7-1/4", RPM rating of at least 5,500
and arbor hole of 5/8" diameter.
2. When mounting the new saw blade,
the direction arrows on the blade
correspond with the arrow on the upper
guard.(See Figure.5)
3. Put the saw in its upper position.
Use supplied allen wrench to remove
the blade bolt. (See Figure. 6)
Caution: This is a reverse threaded screw.
If you turn the screw clockwise, it will
loosen; turn counter clockwise it will
4. Press and hold the spindle-lock button,
and rotate the blade at the same time
until it locks into position.
6. Install a new 7-1/4” TCT blade.
Assembly is reverse order of disassembly,
reattach and tighten all hardware.(See Figure. 8)
MAINTENANCE
5. Rotate the lower blade guard out of the
way and take out the blade (See figure. 7)
tighten.
Fig.Fig.
8
Blade
Inner
Flange
Outer
Flange
Blade
Bolt
Arrow
Fig. 5
Spindle-lock
Fig. 6Fig. 6
Fig.Fig.
7
power cord of the miter saw