241-9964 4-1/2 IN. ANGLE GRINDER Operator’s Manual SAVE THIS MANUAL You will need this manual for safety instructions, operating procedures and warranty. Put it and the original sales receipt in a safe dry place for future reference.
IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric tools, machines or equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury. READ ALL INSTRUCTIONS BEFORE USING THIS TOOL 1. WARNING Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock , fire and/or serious personal injury. 2. WORK AREA a. Keep your work area clean and well lit.
IMPORTANT SAFETY INSTRUCTIONS 5. TOOL USE AND CARE a. Use clamps or other practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body is unstable and may lead to loss of control. b. Do not force tool. Use the correct tools for your application. The correct tools will do the job better and safer at the rate for which it is designed. c. Do not use tools if switch does not turn it on or off.
SAFETY PRECAUTIONS FOR ANGLE GRINDER USE ONLY WITH GUARD IN PLACE. The guard protects you, the operator, from broken pieces of the wheel should it shatter in use. ALWAYS CHECK THE SPEED RATING OF ACCESSORIES. This tool will spin accessories at 11,000 rpm. Accessories not rated for speeds this high may fly apart and could cause serious injury. SPECIFICATIONS Angle Grinder ■ ■ ■ ■ ■ ■ Voltage: 120 volts,60Hz Current rating: 5.
OPERATING PROCEDURES Grinding and Cut-off Wheels This angle grinder is designed to accept only abrasive discs with a 7/8” bore. Check to ensure that any discs used on this machine are rated for the 11,000 rpm speed of this grinder. Check also for any damage to an abrasive disc before installing. Any disc that is cracked, has been dropped, or subjected to other damage due to temperature extremes or solvents should be discarded.
MAINTENANCE Check the brushes occasionally (after about 60 hours of use) and replace if worn. Unplug the tool. Unscrew the round brush covers on each side of the body and pull the brushes out to check or replace them. If you replace the brushes, run the tool without load for 15 minutes to seat the brushes properly. Keep the vents clear of dust and debris. This will help prevent possible electrical shorts and ensure proper cooling.
SCHEMATIC DRAWING WARNING: Repairs should be made by an authorized repair center. Do not open or disassemble this power tool.
TOOL SHOP® 4-1/2" ANGLE GRINDER WARRANTY