Installation Instructions

D
E
C
A
B
4
1 wood cutting blade
Voltage:120V AC, 60Hz.
Current rating: 3.0 Amp
No load speed: 3,000 /min
Maximum depth of cut: 2-3/16” (Wood), 1/4” (Steel)
OPERATING PROCEDURES
Blades
Your jigsaw is designed to accept standard “T” and “U” shank jigsaw blades.
Check to ensure that any blades you use on this machine are designed for the task.
Installing a saw blade
1. Important: Unplug the saw.
2. Loosen the two hex screws on the saw blade clamp.
3. Insert the saw blade into the clamp and slide it in as deeply as it will go.
4. Be sure the blade is seated firmly in guide roller slot.
5. Tighten the hex screws to secure the blade.
6. Before you plug in the power cord, always pull on the blade sharply to ensure it
is firmly held in the blade clamp. Failure to do so may result in injury.
Adjusting the angle of cut
1. Loosen the two hex screws under the baseplate.
2. Slide the baseplate back about 5/16” (8mm)
3. Rotate the baseplate to the desired angle. The angles are clearly marked
on the baseplate.
4. Be sure the blade support roller, which is clamped in position by the same two
screws, is seated with its slot against the back of the blade.
5. Tighten the two screws.
To return to a vertical position
1. Loosen the screws under the baseplate.
2. Rotate the baseplate so that the ‘0’ line shows clear of the housing.
3. Slide the baseplate forward, which locks it in the vertical position.
4. Be sure the blade support roller, which is clamped in position by the same two
screws, is seated with its slot against the back of the blade.
5. Tighten the two screws.
Includes:
A. Blade clamp
B. Protective cover
C.
On/Off trigger
Lock-on button
E.
D.
Hex key
SPECIFICATIONS
FUNCTIONAL DESCRIPTION
OPERATING PROCEDURES
1 hex key stored in the housing below the
cord sheath