Use And Care Manual

BATTERY INSTALLATION
1. Remove the battery pack from the tool by squeezing the two release tabs on the battery pack together
and slide the battery pack out of the tool (see Figure 3)
.
2. Remove battery pack cover from the battery holder by squeezing the two tabs (see Figure 4) and pull
away from the battery holder.
BATTERY PACK
COVER
RELEASE TABS
BATTERY PACK
COVER
BATTERY
HOLDER
3. Paying special attention to the orientation of the batteries, insert four AA batteries into the
battery pack cover. Note the battery holder showing correct battery direction (see Figure 5).
5
4. Align arrow in battery pack cover with arrow in the battery holder and press together (see Figure 6).
The two parts will only fit together when the arrows are aligned. The two parts will join together with a
click.
5. Insert the battery pack into the tool by aligning the indicating arrows (see Figure 7). The parts will
only fit together when the two arrows align and will join together with a click.
**WARNING!** RISK OF FIRE. USE 1.5V ALKALINE BATTERIES ONLY.
**WARNING!** Do not install the batteries backwards.
6
Figure 3
1. Cordless Rotary Tool
2. Battery Pack
3. Release Tab
Figure 4
Figure 5
Figure 6
Figure 7