User manual

Indirect measurement with partial height calculation (ill. 4)

1. Turn on the device.

2. Push the button

(6) until the display shows the symbol .

3. The rst leg to be measured ashes in the symbol (

). Push the

button to take a measurement. The measured value is moved

to the upper line.

4. Measure the next legs (heed the symbol). When measuring the

horizontal leg, hold the device as level as possible.

5. The calculated partial height (

) is shown in the lower line.

n) Angle functions and inclination measurement

In angle functions and inclination measurement mode, the angle “θ” and

legs are used to calculate results.

» The inclination may not exceed ±65° (-65° ≤ θ ≤ 65°) along the

longitudinal axis.

» The device itself may not be tilted more than ±10° along the

lateral axis during measuring.

» The angle display will automatically set to "---" when one of these

values is exceeded.

Measuring procedure

1. Turn on the device.

2. Push the button

(4) until the display shows the desired

measuring procedure. The measuring procedures are explained

below.

3. The angular degrees (inclination) are shown continuously in the

upper line.

4. The rst leg to be measured ashes in the symbol (e.g.

). Push

the button to take a measurement. Depending on the measuring

procedure, you may need to measure additional legs. Proceed as

indicated by the symbol on the display.