Certifications 2

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 1438457
Material Safety Data Sheet
EMERGENCY LIMITS
Ingredient Material name TEEL-1 TEEL-2 TEEL-3
tin Tin 6 mg/m3 67 mg/m3 400 mg/m3
copper Copper 3 mg/m3 33 mg/m3 200 mg/m3
Ingredient Original IDLH Revised IDLH
tin Unknown mg/m3 / 400 mg/m3 / Unknown ppm 25 mg/m3 / 100 mg/m3
copper N.E. mg/m3 / N.E. ppm 100 mg/m3
8.2. Exposure controls
8.2.1. Appropriate engineering controls
 Metal dusts must be collected at the source of generation as they are potentially explosive.
 Avoid ignition sources.
 Good housekeeping practices must be maintained.
 Dust accumulation on the floor, ledges and beams can present a risk of ignition, flame propagation and secondary
explosions.
8.2.2. Personal protection
Eye and face protection
 Safety glasses with side shields.
 Chemical goggles.
 Contact lenses may pose a special hazard; soft contact lenses may absorb and concentrate irritants. A written policy
document, describing the wearing of lenses or restrictions on use, should be created for each workplace or task.
Skin protection
See Hand protection below
Hands/feet protection
The selection of suitable gloves does not only depend on the material, but also on further marks of quality which vary from
manufacturer to manufacturer. Where the chemical is a preparation of several substances, the resistance of the glove material
can not be calculated in advance and has therefore to be checked prior to the application.
Page 11 of 26