Certifications 2

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 1438457
Material Safety Data Sheet
The exact break through time for substances has to be obtained from the manufacturer of the protective gloves and has to be
observed when making a final choice.
Personal hygiene is a key element of effective hand care.
 Protective gloves eg. Leather gloves or gloves with Leather facing
Experience indicates that the following polymers are suitable as glove materials for protection against undissolved, dry solids,
where abrasive particles are not present.
 Polychloroprene.
 Nitrile rubber.
 Butyl rubber.
Body protection
See Other protection below
Other protection
 Overalls.
 P.V.C. apron.
 Barrier cream.
Thermal hazards
Not Available
Respiratory protection
Particulate. (AS/NZS 1716 & 1715, EN 143:000 & 149:001, ANSI Z88 or national equivalent)
Required Minimum
Protection Factor
Half-Face Respirator Full-Face Respirator Powered Air Respirator
up to 10 x ES P1
Air-line*
-
-
PAPR-P1
up to 50 x ES Air-line** P2 PAPR-P2
up to 100 x ES - P3 -
Air-line* -
100+ x ES - Air-line** PAPR-P3
* - Negative pressure demand
** - Continuous flow
A (All classes) = Organic vapours, B AUS or B1 = Acid gasses, B2 = Acid gas or hydrogen cyanide (HCN), B3 = Acid gas or
hydrogen cyanide (HCN), E = Sulfur dioxide (SO2), G = Agricultural chemicals, K = Ammonia (NH3), Hg = Mercury, NO =
Oxides of nitrogen, MB = Methyl bromide, AX = Low boiling point organic compounds (below 65 degC)
Page 12 of 26