User manual

7. Operation

a) Fitting

Fit the additional hand grip

• SeegureB.

• The additional handle can be attached on the left [1] or o n the right [2] of

the product.

• Screwtheadditionalhandgriprmlyintothethreadedholeontheappliance.

Permissible grinding tools

• The permissible maximum rpm or cutting speed of the abrasive bodies used must comply with the details in the

table below.

• Therefore please observe the permissible rpm or peripheral speed on the label of the abrasive body.

• Always use the intermediate layers enclosed with the abrasive bodies: they are positioned between the abrasive

bodyandtheclampingangeandmustbeatleastthesamesizeasthecontactsurfacesoftheanges.

• When using abrasive bodies with threaded inserts, it must be ensured that the end of the spindle never touches the

perforated plate of the grinding tool.

• Abrasive bodies with threaded insert must be able to be screwed onto the grinding spindle far enough that they

rmlytthegrindingspindleangeattheendofthegrindingspindlethread.

Fitting the abrading disc

Risk of injury! Never use damaged abrading discs. Always check the abrading disc for cracks or other

damagebeforettingit.Useonlyabradingdiscswhosepermittedrotationalspeedisatleastashighasthe

idling speed of the appliance.

Risk of injury! The permitted diameter for the abrading disc must always be complied with.

Risk of injury! Use only abrading discs which are permitted for the material being worked with.

• SeegureC.

• Press the spindle locking button on the top of the tool and keep it pressed.

• Unscrewangenut(7).

• Place the abrading disc onto the spindle. Comply with the required

installation position of the abrading disc.

• Placetheangenutontothespindle.

• Notetheinstallationpositionoftheangenut:

• Flange pointing away from abrading disc: for thin discs such as cutting discs.

• Flange pointing towards abrading disc: for thicker discs such as abrading

discs.

• Tightentheangenutusingthefacepinwrenchprovidedwhilepressingthe

spindle locking button.

Fig.B

Fig.C