User manual

25
b) Commissioning
• SeegureA.
Adjusting the protective bonnet
The protective hood must be adjusted so that it prevents sparks and particles from being thrown in the direction of
the user.
• Loosen bolt (5).
• Adjusting the protective hood
• Retighten bolt (5)
c) Operation
Risk of injury! Let the appliance idle for a few seconds before use. When vibrations start to occur, replace
the abrading disc immediately.
 Riskofinjury!Theappliancemustbeusedonlywiththeadditionalhandgripttedandtheprotectivehood
correctly adjusted.
Check before switching on
Check the safe condition of the appliance:
• Check it for visual defects.
• Checkthatallpartsofthemachinehavebeensecurelytted.
Switching on/off
Risk of injury!After switching off, the appliance continues to run on for a few seconds. Waiting until the
abrading disc has come to a stop before laying the appliance down.
In case of a loss of power, an under-voltage relay triggered. This prevents the product from restarting by
itself as soon as the power is restored.
• SeegureD.
• To switch on again the product must be turned off at the main switch and
then turned back on.
- Switching on: Press the On-Off switch (1), at the same time, slide forwards
and allow it to engage in position [1].
- Switchingoff:PresstheOn-Offswitch(1)brieyandallowittoglideback
to position [0].
2 1
Fig.D