User manual

24
7. Operation
Read the instruction book carefully. Make sure that all the products’ packaging has been removed. Ensure
that the voltage indicated on the rating label matches the main voltage before plugging in the appliance.
a) Integrated dust extraction with microlter
• SeegureA.
• Always use the appliance with the dust box (2) connected, inhaling dust
is harmful to your health.
• Connectthedustbox(2)tothelterconnector(5)
b) Empty the dust box
• SeeguresC,DandE.
• To empty the dust box, pull off the dust box (2)
• Removethelterlid(6)pullingitasitisshowningD.
• Removethelterelement(7)fromthedusttank(8).
• Cleanthelterelement(7)andthedusttank(8)withasoftbrush.
c) Replacing the sanding sheet
• SeegureB.
• To remove the sanding sheet (3), grasp it at one of the tips and pull it off
from the sanding plate (4).
• Pay attention that punched holes of the abrasive sheet (3) match with
the holes of the sanding plate (4).
• Positionthesandingsheet(3)ushalongsideoneedgeofthesanding
plate (4).
• Laythesandingsheetontothesandingplateandpressrmly.
• To remove the sanding sheet (3), grasp it at one of the tips and pull it off
from the sanding plate (4).
d) Switch on and switch off
• SeegureA.
• To start the tool, press the on/off switch to “I” ON position (1).
• To stop the tool, press the switch to “O” OFF position (1).
3
Fig.B
2
Fig.C
6
8
Fig. D
7
8
Fig. E