User manual

41
c) Disabling the xed soldering tip temperature
Asdescribedinsection10.b),ifyouhavesetaxedsolderingtiptemperature,thesolderingstationwillautomatically
heat the soldering iron to the preset temperature when it is switched on. The temperature cannot be changed using
the control buttons (2) or the temperature control dial (7).
To disable this function and set the temperature using the control buttons (2) or the temperature control dial (7), follow
the steps below:
• Enable settings mode as described in section 10. a).
• Press button “1” when the main menu is displayed.
• “SETTEMP.”willappearbrieyonthedisplay.
“ENT.PASS 000” will be displayed.
• Use the three control buttons (2) to enter the password.
“1” = Decrease value
“2” = Choose input position
“3” = Increase value
• Holddown button“2” toconrm yourentry.The passwordwill ashthree timesand “SETTEMP000”will be
displayed.
• Leave the temperature setting at “000”.
 Saving“000”disablesthexedsolderingtiptemperature.Settinganothertemperature(“050”....”480”)only
changesthexedtemperature.Thenewsettingtakeseffectthenexttimeyourestartthesolderingstation.
 Alwayssetthetemperatureto“000”ifyouwishtodisablethexedtemperaturefunction.
• Holddownbutton“2”.“000”willashthreetimesand“SETTEMPSUCCESS”willbedisplayed(=temperature
was successfully set).
• After a few seconds the display will revert to the main menu (see screenshot in section 10. a).
• Switch the soldering station off using the on/off switch (1).
• After you switch the soldering station back on, you can use the control buttons (2) or the temperature control dial
(7) to manually change the soldering tip temperature.
 Ifyouwishtoprogramaxedsolderingtiptemperature,followthestepsinsection10.b).