Instructions
30
Make sure the impact wrench is connected to the air pressure source using a correct sequence
of system components, and that hose, lters and connection couplers are properly tted and in
good working condition. Below piping model is for reference only.
1 2 3 1 2 4 5 6
7
1 Quick connector
2 Quick coupler
3 Air hose
4 Lubricator
5 Regulator
6 Filter
7 Cut off valve
• Check that the compressed air supply is clean and dry.
• Set the compressor’s pressure regulator to 6.2 bar (90 psi).
• Do not turn the compressor on until you are ready to use the impact wrench.
b) Forward and Reverse Setting
• To set forward (clockwise) rotation, ip the valve switch (A7) F.
• To set reverse (anti-clockwise) rotation, ip the valve switch (A7) R.
c) Air Regulator (Torque Adjust)
• There are three torque settings for forward and one for reverse.
The impact wrench will operate at maximum power in reverse.
Max. loosening torque 1,756 Nm.
• Adjust the control valve dial (A6) to the desired torque level.
- The smaller the circle the lower the torque.
- Use the lowest setting that will perform the task.
Compressor