Instructions

3. After use, set the on/off switch lock to the center position to

prevent accidental operation (Ú Fig. 5).

Fig. 5

b) Setting the operation mode

Symbol Mode Application

Impact drilling Brick, concrete, stone, etc.

Normal drilling Wood, metal, plastic, etc.

1-19 Screwdriver Driving/removal of screws

The mode selector ring (4) can be used to set desired torque (1-19) depending on the different type of

screws/material. The proper setting depends on the type of material and the size of the screw. Position 1

denotes lowest setting and position 19 the highest setting.

The torque depends on the impact duration. The maximum torque is achieved after impact duration of 5-7

seconds. After that time, the tightening torque is increased only minimally. The actually achieved tightening

torque should be always checked with a torque wrench.

Fig. 6 Fig. 7 Fig. 8

1-19