Instructions

25
6. Operating elements
(Ú Fold-out page)
1 On/off switch with variable speed
2 Work light
3 Tool holder
4 Tighten/loosen rotation control switch
5 Belt clip
6 Battery pack (not included)
7. Setup and preparation
Switch the product off and remove battery pack before assembly, cleaning, adjustments, maintenance,
storage and transportation.
Always wear gloves when handling the product.
a) Installing bits
Due to the impact mechanism you should use only bits, which are designed for operation with impact
screwdrivers of greater or equal torque than the torque of the product.
Installation must be carried out when the battery is removed from the product to prevent injury.
The product cannot be used with standard drill bits.
The bits are not supplied with the product. Use bits with the chuck size of 6.3 mm (1/4 in).
1. Pull the locking sleeve of the tool holder (3) (Ú Fig. 1).
2. Insert the bit into the opening of the tool holder. Release the locking sleeve (Ú Fig. 2).
Fig. 1
Fig. 2