Manual

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights
including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2020 by Conrad Electronic SE. *1933085_v1_0420_02_dh_m_app_en
Serial port commands
Command Description
C?0 Help
C00 Restore factory settings
C10 Check the temperature of all channels
C11 Check the temperature of Channel 1
C12 Check the temperature of Channel 2
C13 Check the temperature of Channel 3
C20 Open all channels
C21 Open Channel 1
C22 Open Channel 2
C23 Open Channel 3
C24 Open desoldering pen
C30 Close all channels
C31 Close Channel 1
C32 Close Channel 2
C33 Close Channel 3
C34 Close desoldering pen
Indicatesthedatatobelledinbytheuser,_indicatesnoneedoflling
C41 Temperature unit selection °C 0; °F 1
C42 Tone switch On 0; Off
If the input value has less than 3 digits, use 0 to supplement;
C51 Temperature value setting of Channel 1 (150-500°C/302-932°F)
C52 Temperature value setting of Channel 2 (150-500°C/302-932°F)
C53 Temperature value setting of Channel 3 (150-500°C/302-932°F)
C54 Air ow value setting of Channel 3 (150-500°C/302-932°F)
C61 Temperature calibration value of Channel 1 (-50-50°C/-90-90°F)
C62 Temperature calibration value of Channel 2 (-50-50°C/-90-90°F)
C63 Temperature calibration value of Channel 3 (-50-50°C/-90-90°F)
C71
Sleep time setting of Channel 1 (0 - 120)
(default value at delivery is 0 minute, no sleep)
C72
Sleep time setting of Channel 2 (0 - 120)
(default value at delivery is 0 minute, no sleep)
C80 Parameter locking for all channels Unlock 0 Lock 1
C81 Parameter locking for channel 1 Unlock 0 Lock 1
C82 Parameter locking for channel 2 Unlock 0 Lock 1
C83 Parameter locking for channel 3 Unlock 0 Lock 1
Error codes
Code Possible reasons
E-1 : thermal
fuse fault
The heating unit (of the soldering iron, desoldering gun, soldering tweezers
or hot air nozzle) is faulty or there is a contact problem.
E-2: sensor
alarrn
The temperature sensor (of the soldering iron, desoldering gun, soldering
tweezers or hot air nozzle) is faulty or there is a contact problem.