Manual

36
7Removing grinding tools
• Placethegrindingstone(16)onaatsurface,holditinplaceandguidethesandingtoolthatyouwanttoremove
in a straight line back and forth along the entire length of the grinding stone at the desired angle. Do not pass the
grinding tool over the edge of the sharpening stone. They will slide off.
When working on the rotating tool, do not only press on one point of the sharpening stone. This may pro-
duce a groove in the sharpening stone if repeated several times.
c) Working with the exible shaft
Installthetoolrequiredforyourworkintothecolletchuckinthehandleoftheexibleshaftinsteadofdirectlyinthe
multi-purposetool.Youcanthenworkwiththisextension.Workingwiththeexibleshaft(17)allowsyoutoreach
areasthataredifculttoaccess.Tousetheexibleshaftwhenworking,themulti-purposetoolmustbesuspended
from the supplied stand (18).
1Inserting or replacing tools
Toinstall,insertorreplacetoolsontheexibleshaft(17),proceedasfollows:
1. Turn the shaft slightly until the holes on the shaft and the handle are aligned with each other.
2. Insert the hex key (14) into the holes to lock the shaft.
3. Use the wrench (13) to loosen or tighten the collet chuck (on the handle).
4. Follow the steps below to mount, assemble or replace the tool. Refer to the instructions in section "a) Clamping
tools". Locking by means of the spindle lock is not necessary here. The hex key is used for this purpose.
Do not loosen or turn the shaft when unscrewing it before you have locked it in place. This may damage
theexibleshaft.