Instructions / Assembly

........................... ...........................

HOW TO OPERATE YOUR CEILING FAN

Restore electrical power to the outlet box by turning on the electricity at the main

fuse box. To make the fan operational, open battery door by pressing and sliding

down the battery door. Install a 23A 12V batteries into the hand-held remote

transmitter(if not used for long periods of time, remove the batteries to prevent

damage to the transmitter).

1.The remote control adopts RF wireless digit emission technique, biunique

controlled, coincident code rate is less than one millionth.

2.The transmitter and receiver are pre-matched at the factory. Please follow below

step#3 if they don't work well.

3.Turn off the fan power and then restore it, press and hold the "fan stop" button for

3 seconds, within 10 seconds after you restore the power, then you'll hear a beep

sound from the fan, with the light flashestwice, which means the pairing process is

completed.(NOTE: The pairing process is not accepted after 10 seconds when you

restore supply power)

4. Please note that the transmitter can pair with multiple receivers. When the

transmitter does not control the receiver, please check if any similar remote controls

are working nearby, disconnect them and then proceed with pairing process again.

5.Store the remote transmitter away from excessive heat or humidity.

6. Battery of low power or not-used for long time should be replaced.

23A 12V