Instructions / Assembly

.................................. ..................................
6
Feed motor lead wires through downrod/canopy assembly and insert downrod into
downrod yoke. Make sure to align hole in downrod with the hole in downrod yoke.
Install yoke cross pin (1) through yoke and downrod. Insert clamp pin (2) into cross pin
until it snaps into place. Tighten set screws (3) in yoke.
2
1
3
7
NORMAL DOWNROD OPTION
............... ............... ... ...
SAFETY CABLE INSTALLATION
8
9
MOUNTING
Carefully lift fan assembly onto mounting
bracket. Rotate fan until notch on
downrod ball (1) engages the ridge on
the mounting bracket (2). This will allow
for hands free wiring.
For Canadian installation and for USA fan
and light kit combinations over 35 lbs,
the safety cable must be installed into
the house structure beams. Make sure
that when the safety cable is fully
extended the leadwires are longer than
the cable and no stress is placed on the
lead wires.
Note: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.