User Manual

❏ 4. Use a fine-point felt-tip pen to mark small lines
directly on the wing, noting the location of both wing bolt plates. Reposition the air scoop on the wing, then mark the same lines on both sides of the air scoop.
❏ 5. Cut the inside of the air scoop at the lines to
accommodate the wing bolt plates.
❏ 6. Use the same procedure to mark the location of
the wing bolts on the air scoop. Using the marks on the scoop as a guide, cut 1/2" [13mm] holes through the bottom of the scoop for wing bolts.
❏ 7. Roughen the lip around the base of the scoop
so glue will adhere. Place a sheet of wax paper between the wing and the fuselage.
❏ 8. Glue the air scoop to the bottom of the wing with
30-minute epoxy mixed with microballoons. Hold the air scoop down with weights and use paper towel squares dampened with alcohol to clean up epoxy that squeezes out.
❏ 9. Unbolt the wing after the epoxy hardens. Slip pieces of fuel tubing over the wing bolts so they don’t fall out.
Wing fairing ❏ 1. Bolt the wing to the fuselage. Test fit the
fiberglass wing fairing to the wing and fuselage.
Trim the wing fairing as necessary to fit.
❏ 2. Trace the outline of the wing fairing onto the wing.
Cut away the covering 1/32" [1mm] inside the line.
❏ 3. Roughen the inside of the wing fairing around
the edges where it will contact the wing. Holding the wing fairing in position, glue it to the wing with medium CA.
- 34 -