Owner manual

❏ 26. Mark a centerline around the tips, then glue
them into position. Using the centerlines as guides, carve and sand the tips to match the stab, then round to a finished shape.
❏ 27. The same as was done on the fin and rudder
corrugations, get out your putty knife and wood filler and partially fill all of the corrugations on both sides of the stab. Allow to dry, then sand.
BUILD THE WING
MAKE THE WING SKINS ❏ 1. Cut the wing center panel plan from the wing
plan. Cover the plan with Plan Protector or wax paper and place it over your flat building board.
❏ 2. Cut four 1/16"x 3"x 30"[1.6 x 75 x 760mm] balsa
sheets into twelve 3"x 10"[75 x 250mm] balsa sheets. Set one of the 3"x 10"[75 x 250mm] sheets in your scrap pile and cut another one of the 3"x 10"[75 x 250mm] sheets into two 1-1/2"x 10"[38 x 250mm] sheets.
❏ 3. Glue the sheets together as shown in the
previous photo to make a forward and aft center panel skin. Make two of each.
❏ 4. Sand the skins flat and even.
BUILD THE CENTER PANEL
❏ 1. Glue a die-cut 1/8"[3.2mm] plywood rib
doubler 1A to both sides of a die-cut 3/32"[2.4mm] balsa rib W1. Make another assembly the same way.
❏ 2. Cut the balsa from between the dowel notches
in both rib assemblies.
❏ 3. Referring to the plan, glue the four die-cut
1/8"[3.2mm] plywood doublers W1B to the opposing sides of the outer two ribs that will go on both ends of the center panel.
- 18 -