Owner manual

❏ 10. When covering the wings, start with the wing
tips, then cover belly pan. First cover the front and back of the belly pan, then apply a 1/4"[6mm] strip of covering as shown. Now cover the bottom of the wing, the belly pan and then the top of the wing to match the trim scheme you have selected.
❏ 11. Flat black MonoKote may be used to simulate
the walkway on the right wing and flap.
❏ 12. When covering the ailerons, flaps and rudder,
don’t forget to cover the corrugations to match your trim scheme.
❏ 13. Cut a narrow strip of covering from all of the
CA hinge slots in the wing and ailerons and in the fin and rudder. Without using any glue, temporarily join the ailerons to the wing, then add the gold striping.
❏ 14. If applying the gold stripes to the fin like the
model on the kit box, first cut the stripes as shown. Cut them over a cutting mat if you have one.
❏ 15. Apply the stripes to the fin so the excess
material wraps around the leading edge.
❏ 16. Use a sharp, single-edge razor blade to cut the
covering around the leading edge.
- 60 -