Owner manual

❏ 9. Now that the servos have been installed in the
wing, guide the air lines for the retracts through the wing, then connect the lines to the retracts. Whichever way you connect the colored lines, hook them up the same on both landing gears. Mount the landing gear in the wing.
❏ 10. Glue strips of plastic or balsa across the openings
in the wing to retain the air lines and the servo wires so they will not interfere with the landing gear.
❏ 11. Mount the air tank in the fuselage. Use RTV
silicone or epoxy to glue it in place.
❏ 12. Glue pieces of leftover pushrod guide tubing to
the back of the servo rail, then guide the air line coming from the air tank through the tubes.
❏ 13. Cut rounded notches near the top of the
formers as shown. These will accommodate the air line from the tank and the rudder and stabilizer servo wires when the cockpit kit has been installed.
❏ 14. Make a battery mounting plate from leftover
plywood, then glue hardwood sticks across the bottom. Mount the receiver battery to the plate using rubber bands with R/C foam rubber in between. Securely glue the battery inside the fuselage where shown on the plan, or in another strategic location.
- 64 -