Owner manual

❏ 23. If you have not done so already, assemble, paint
and install the cockpit kit according to the instructions included with it. Guide and secure the aileron and flap servo extensions under the cockpit floor.
MOUNT THE PILOTS Two Williams Brother’s #62600 Sportsman 3"(1/4- scale) pilots (WBRQ2626) were mounted in this model. Even though the model is slightly smaller than quarter-scale, these pilots look best.
❏ 1. Make a mounting platform from leftover
3/32"hard balsa. The platform fits between the fuselage side stringers and will be glued to the bottom of the cabin frame. Paint the platform flat black. Note that the sides have been masked from the paint to expose the wood for a better glue joint to the bottom of the cabin frame.
❏ 2. Cut a notch in the outer shoulder of both pilots
to accommodate the cabin frame.
❏ 3. Shape, then glue sheets of leftover 1/8"[3.2mm]
plywood inside the base of both pilots.
❏ 4. Glue the mounting platform to the bottom of the
cabin frame. Be certain the platform will fit between the fuselage side stringers when the cabin top is on the fuselage.
❏ 5. Place one of the pilots on the platform. Drill two
3/32"[2.4mm] holes through the platform and the bottom of the pilot. Enlarge the holes in the platform, then mount the pilot to the platform with two #4 x 1/2"[13mm] screws and washers (not included).
❏ 6. Mount the other pilot the same way.
- 66 -