User Instructions

2. Position the graphic, then wipe away most of the solution with a paper

towel.

3. Use a piece of soft balsa to thoroughly squeegee out all of the solution.

Allow to dry at least overnight – 24 hours or more is even better.

4. After all residual solution has evaporated from between the graphic and

the main layer of MonoKote you must iron it down with medium heat.

FINISH THE SERVO HATCH

Material over hatches and other openings should also be cut oversize

so excess MonoKote can be ironed down inside the edges to provide a

 nished opening and a good seal.

1. Use a straightedge to cut the covering 1/4” [6mm] inside the edges of the

opening.

2. Slit the covering in from the corners.