User Manual

This device is intended only for OEM integrators under the
following conditions:
1) The antenna must be installed such that 20 cm is
maintained between the antenna and users, and
2) The transmitter module may not be co-located with
any other transmitter or antenna.
As long as 2 conditions above are met, further transmitter
test
will not be required. However, the OEM integrator is still
responsible for testing their end-product for any additional
compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements,
etc.).
IMPORTANT NOTE: In the event that these conditions can not
be met (for example certain laptop configurations or co-location
with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID can not be used on the
final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device
where the antenna may be installed such that 20 cm may
be maintained between the antenna and users (for
example : Access Point, Router…etc.). The final end
product must be labeled in a visible area with the following:
“Contains TX FCC ID: SUMMB8000G”.
Manual Information That Must be Included
The OEM integrator has to be aware not to provide
information to the end user regarding how to install or
remove this RF module in the user’s manual of the end
product which integrate this module.
The users manual for OEM integrators must include the
following information in a prominent location “ IMPORTANT
NOTE: To comply with FCC RF exposure compliance
requirements, the antenna used for this transmitter must be