User's Manual

1. Press the Shuttle Knob or OSD Key to make the OSD window appear. See

figure 4.

2. Rotate the Shuttle Knob to select the desired function. See figure 4.

3. Press the Shuttle Knob again to select the function that you want to adjust.

4. Rotate the Shuttle Knob to change the settings of the current function.

5. When the OSD window is active, it shows the input signal timing. The "H"

stands for the horizontal frequency and "V" for the vertical frequency.

6. To exit and save, either press the OSD Key, select the exit function, or leave

the monitor alone for 10 seconds. If you want to adjust any other function,

repeat steps 2-4.

V: 85Hz

9300 6500

H: 68.8KHz

Contrast

Figure 4 The OSD Message

The description for function control LEDS

1. CONTRAST Adjust the picture contrast.

2. BRIGHTNESS Adjust the picture brightness.

H- CENTER

Adjust the horizontal position of the picture.

4. H- SIZE Adjust the picture’s horizontal size.

5. V- CENTER Adjust the vertical position of the picture.

ADJUSTING THE PICTURE

HOW TO ADJUST A SETTING