Operation Manual

Babytalker 1020
6
®
5.4.2 Connecting the baby unit to the mains
- Plug the small connector of the power adapter into the
power adapter jack on the side of the baby unit. A click
indicates, the jack is locked into position.
- Connect the power adapter (7,5V DC / 300mA) to a mains
socket (230-240V~ 50Hz).
5.4.3 Inserting batteries into the parents' unit
- Remove the belt clip.
- Push the battery cover and slide it downwards.
- Install the rechargeable battery pack following the polarity as
illustrated.
- Re-install the battery cover and belt clip.
5.4.4 Charging batteries in the parents' unit
- Connect the power adapter (7,5V DC / 300mA) to a
main socket (230-240V~ 50Hz).
- The flashing battery charge indicator in the display
shows that the batteries are being charged:
6 Operating the device
6.1 Switching the parents' unit and baby unit on and off
- Press the on/off button to switch on the parents' unit. The display illuminates.
- To switch on the baby unit, press the on/off button . The display illuminates.
- To switch off the parents' unit, press and hold the on/off button until the display goes out
- To switch off the baby unit, press and hold the on/off button until the display goes out.
6.2 Setting the channel
To have communication between the baby unit and the parents’ unit they need to be set both on the same channel.
- Press the channel up or channel down button on the parent to select the channel of the parent
unit.
- Press the channel up or channel down button on the baby unit to select the same channel of
the parent unit.
Once both units have the same channel, the parents’ unit can receive the signal from the baby unit.
When on one or both units is displayed, the privacy mode is activated. Check chapter “Activating privacy mode”
on page 7
.
• Only use the enclosed power adapter.
WARNING
Injury and material damage can be caused by using
non-rechargeable batteries in the parents' unit!
• Only use the Ni-MH battery pack supplied with the
product.
• The parent unit can only be used with the
enclosed a Ni-MH battery pack. It cannot
be used with single cell Ni-MH batteries!
• The batteries take about 12 hours
to charge.
• The batteries are charged continuously.
Therefore the flashing battery charge
indicator in the display is still visible even
when the batteries are fully charged.
22
MADE IN CHINA
MUST BE RECYCLED OR DISPOSED OF PROPERLY
Ni-MH
13
13
9
18
14
9
18
3
4
15
16