Operation Manual

Babytalker 1020

ENGLISH

6.3 Activating privacy mode

The Babytalker 1020 operates on free frequencies (PMR - 446Mhz).

Any other PMR device in range, on the same channel can hear the transmitted babyphone signal.

This means also that the parents’ unit can receive the signal from other PMR devices.

To avoid disturbance from other PMR devices, privacy mode must be activated on both parents’ and baby unit.

Once the channel on the parents’ unit and baby unit is the same,

- Press the set button once to activate privacy mode on the parent unit.

- Press the set button once to activate privacy mode on the baby unit.

6.4 Setting the transmission volume of the parents' unit

There are 8 volume levels.

- Press the button to increase the volume.

- Press the button to decrease the volume.

6.5 Setting microphone sensitivity (VOX)

The baby unit operates on VOX mode. This means that the baby unit starts sending as soon as the microphone

detects sound. The sensitivity of the sound detection can be changed by the user.

When you increase the sensitivity, the baby unit picks up quieter sounds.

The VOX sensitivity can be adjusted by turning the VOX sensitivity switch ;

- Clockwise to the highest VOX sensitivity position

- Counter clockwise to the lowest VOX sensitivity position

6.6 Feeding timer

The feeding timer is a count down timer that can be used for generating an alarm sound to remind you of the next

feeding or medicine time.

To turn on the count down timer and set the timer.

- Press and hold the set button for 5 seconds. The feeding timer icon and feeding time interval

is displayed.

- Press the channel up button to select the hour.

- Press the channel up button to select the minutes.

- Press the set button to confirm.

Once the alarm is audible, press any button (except the On/Off button) to deactivate.

6.7 Night light on the baby unit

- Press the night light button to activate the LED night light .

- Press the night light button again to deactivate the LED night light .

6.8 LED light on the parents’ unit

- Press the LED light button to activate the LED light .

- Press the LED light button again to deactivate the LED light .

IMPORTANT:

When the baby unit is transmitting (TX on the display), the channel cannot be

set. The channel up or channel down button will not respond.

Make sure that the VOX sensitivity switch is set to minimum (Counter clockwise)

and make no excessive sounds while setting the channel of the baby unit.

• When privacy mode is activated, is displayed.

• To deactivate the feeding timer during the countdown, enter this menu function

again and reset the hour and minutes to zero.

15 16

20 21