Operation Manual

Butler 4056/4056C 21
Butler 4056/4056C
ENGLISH
•Press the Up or Down key to select one of the 5 memories.
• Enter the number (max. 5 digits) to be barred, e.g. 01486.
•Press the Programming key .
•‘HS _ _ _ _ _’ (= number on the handset (1-5)) ‘01486’ (= the barred numbers) appear on
the display.
• Enter the numbers of the handsets from which the barred numbers cannot be called.
•e.g. Press the number key 2, 3 and 5. On the display, this will appear: HS _2 3_5 01486
These handsets can no longer dial numbers beginning with ‘01486’.
•Press the Programming key to confirm your selection.
Repeat the same procedure described above if you would like to bar other numbers
(max. 5)!
4.28 DIRECT CALL
By setting a Direct Call number, the phone will automatically take the line and dial out this
number. This function is useful to use the phone as a emergency phone.
4.28.1
To program the Direct Call number
•Press the Programming key
•Press the Up or Down key until ‘DIRECT’ appears on the display
•Press the Programming key
• If necessary, delete the existing number by pressing the Delete-key a few times
• Enter the direct number
•Press the Programming key
4.28.2
Turn the Direct Call function ON/OFF
To turn it ON:
•Press the Programming key
•Press the Up or Down key until ‘DIRECT’ appears on the display
•Press the mute-key for 2s
•‘DIRECT ON’ appears on the display
To turn if OFF:
- Quick press the Programming key twice
4.29 DEFAULT SETTINGS (RESET) OF THE PARAMETERS
You can reset the standard (default) settings in the telephone. You need the PIN code to do
this.
The default settings are:
Keypad: not locked
Key clicks: active
Speaker volume: level
Ringer melody: 1
Ringer volume : 5
Selection base unit: automatic
Flash time: 100ms
To restore the default settings, do the following:
HL_B4056_mideur.book Page 21 Thursday, August 5, 2004 9:01 AM