Manualshelf

Operation Manual

ManualsBrandsTopcom ManualsTelephoneBUTLER 4056
21222324252627282930
22 Butler 4056/4056C
Butler 4056/4056C
•Press the Programming key .
•Press the Up or Down key repeatedly until ‘SETTING’ appears on the display.
•Press the Programming key .
•Press the Up or Down key repeatedly until ‘RESET’ appears on the display.
•Press the Programming key .
•‘PIN’ appears on the display.
• Enter your PIN code.
•Press the Programming key .
4.30 COMPLETE REINITIALISATION OF THE TELEPHONE
This function allows you to completely reinitialise the telephone without requiring your PIN
code. This will delete all Phone Book memory entries, all handsets will be removed, all default
settings will be restored and the default PIN code will be restored to ‘0000’.
Do the following:
•Disconnect the battery in the telephone.
• Keep the ‘*’ key pressed and reconnect the battery until the handset rings continually and
the display lights up. Release the ‘*’ button and press the Programming key .
•The handset finds the base unit and a signal sounds.
•Briefly press the ‘*’ key.
•‘RESET ?‘ appears on the display.
•Press the Programming key to confirm your selection of disconnect the battery to
discontinue the procedure.
•‘RESETTING‘ appears on the display and a long beep tone sounds.
•‘NOT SUB‘ appears on the display. The handset is completely reinitialised.
Afterwards, you must resubscribe all handsets as described in point 4.23! However you no
longer need to set the base unit to subscription mode, because this now happens
automatically!
4.31 SETTING THE HANDSET DIALLING MODE
There are two types of dialling modes:
- DTMF/Tone dialling (the most common)
- Pulse dialling (for older installations)
To change the mode of numeration:
- Press the Programming key
- Press the Up or Down key repeatedly until ‘SETTING’ appears on the display.
- Press the Programming key
- Press the Up or Down key repeatedly until ‘DIAL MODE’ appears on the display.
- Press the Programming key
- Select ‘TONE’ or ‘PULSE’ by means of the UP and Down key
- Press the Programming key to confirm
HL_B4056_mideur.book Page 22 Thursday, August 5, 2004 9:01 AM