Operation Manual

Cocoon 450 22

ENGLISH

5.5.1.

Activating the keypad lock

1. Enter the menu by pressing MENU.

2. Select KEY LOCK.

3. Press OK.

4. Select ON.

5. Press OK to validate.

Note: A double bleep conﬁrms the validation of your choice.

A long bleep signiﬁes that the modiﬁcation has not been taken into account.

5.5.2.

Deactivating the keypad lock

1. Enter the menu by pressing MENU.

2. Select KEY LOCK.

3. Press OK.

4. Select OFF.

5. Press OK to validate.

Note: A double bleep conﬁrms the validation of your choice.

A long bleep signiﬁes that the modiﬁcation has not been taken into account.

5.6. HEADSET CONNECTION

You can connect a headset with a 3 pole jack plug of 2,5mm on the right side of the handset. When

the headset is connected, you can only hear and talk through the headset. The headset

microphone can still be muted by the Mute key. The handsfree speaker can still be activated by

pressing the handsfree key .

6. MANAGING MULTIPLE HANDSETS

6.1. SETTING UP AN ADDITIONAL HANDSET

You can subscribe more handsets to the base if they have the DECT GAP protocol.

The base can support a maximum of 5 handsets. If you already have 5 handsets, and you wish

to change one of them, you must first delete one handset, then subscribe a new one.

1. Put the base into registration mode, by pressing and holding the Paging key on the base

for 6 seconds.

2. The base will then emit a bleep. It is now ready to be associated with a new handset, during

the 90 seconds after pressing the button only.

6.1.1.

If your additional handset is a Cocoon 400/450

3. Enter the menu by pressing MENU.

4. Select REGISTER.

5. Press OK.

6. Enter the base number for this handset, (from 1 to 4). The flashing numbers are the numbers

already used for other bases.

7. Enter the PIN code for the base (0000 by default).

8. If the handset has located the base, it will display the base identification number. Validate the

base association by pressing OK or invalidate by pressing .

9. If the handset does not locate the base, it will return to the previous configuration after a few

seconds. Try again by changing the base number and check that you are not in an

environment where there is interference.