Operation Manual

25 Cocoon 450
ENGLISH
7.2.1.
Setting the base speaker volume
To change the volume during playback of incoming or outgoing messages, press to increase
or to decrease.
7.2.2.
Recording and playback outgoing messages (OGM 1 or OGM 2)
To record an outgoing message:
• Press to enter the answering menu
• Press ‘9’ and then:
- ‘1’ to record OGM 1
- ‘2’ to record OGM 2
• Press the stop key to end the recording. The recorded message will be played. Press
to stop the playback.
To play the recorded messages when you are in the answering menu:
• Press ‘6’ and then:
-‘1’ to play OGM 1
- ‘2’ to play OGM 2
• Press the stop key to end the playback
7.2.3.Selecting an outgoing messa
ge (OGM 1 or OGM 2)
If the memory is full, only outgoing message 2 can be selected (only answering
without recording).
• Press to enter the answering menu
• Press ‘7’ and then:
- ‘1’ to set OGM 1 (answer and recording mode)
‘AR MODE 1’ will be shown on the display
- ‘2’ to set OGM 2 (Answer only mode)
‘AR MODE 2’ will be shown on the display
7.2.4.
Turning Answering Machine On/Off
If the answering machine is On, the LED on the base will light up contiously and the machine
will automatically pick up the line after a number of rings (See “7.2.5. Setting Number of Rings” on
page 26.).
If the answering machine is OFF, the LED on the base will go off.
• Press to enter the answering menu
• Press to switch ON the answering machine. ‘TAD ON’ will be shown and the LED will
lit on the base
• Press to switch OFF the answering machine. ‘TAD OFF’ will be shown and the LED
on the base will go off
Even if the answering machine is turned off, it will automatically pick up the line after 10 - 15 rings
to enable remote activation (See “7.4. Remote Operation” on page 28.).
Note: Answering machine cannot be activated if no OGM is recorded.