Manualshelf

Operation Manual

ManualsBrandsTopcom ManualsTelephonesCocoon 450
21222324252627282930
Cocoon 450 26
ENGLISH
7.2.5.
Setting Number of Rings
The number of rings after which the answering machine will answer calls can be set from 2 – 7
and Economy (Toll saver). The default setting is in economy mode. In economy mode the
machine will answer after 4 rings if there are no new messages, and after 2 rings if there are new
messages. If there are no new messages and you call your machine to check your messages
remotely (See “7.4. Remote Operation” on page 28.), you can hang up after the 2nd ring. You do
not need to pay connection fees and you know that you do not have any new messages.
• Press MENU
• Press up or down a few times until ‘TAD MENU’ appears
• Press OK
• Press up or down a few times until ‘RG DELAY’ appears
• Press OK
• Press up or down a few times until the desired number of rings is set
• Press OK to confirm settings
• Press ‘c’ to exit ‘TAD MENU’
7.2.6.
Setting SOS code and filtering
The SOS code is used to stop the call filter for a short period so that the base station starts to ring
during 8 seconds. The following filter options can be set on the telephone:
OFF: No filter function active
HEAR AR: This mode enables all calls to be heard through the loudspeaker of handset 1
(Call screening). The loudspeaker is switched ON during outgoing- and
incoming message playback/recording. The other handsets cannot receive
calls.
SILEN AR: All calls are immidiatly transfert to the answering machine without any ring
delay. Callers can enter the SOS code starting with ‘*’ to override this function.
The base will start to ring for 8 seconds.
VIPFUNC1: All calls are immidiatly transfert to the answering machine without any ring
delay, except when a number comes in which match with a number from the
phonebook.
VIPFUNC2: All calls will be answered by the answering machine after the ring delay, except
the one number from the phonebook. Callers can enter the SOS code starting
with ‘*’ to override this function. The base will start to ring for 8 seconds.
a. Programming the SOS code
• Press MENU
• Press up or down a few times until ‘TAD MENU’ appears
• Press OK
• Press up or down a few times until ‘SOS CODE’ appears
• Press OK
• Enter the current code (default = ‘111’)
• Press OK
• Enter the new code and press OK
• Enter again the new code for confirmation and press OK