Operation Manual

27 Cocoon 450
ENGLISH
b. Setting the filter options
• Press MENU
• Press up or down a few times until ‘TAD MENU’ appears
• Press OK
• Press up or down a few times until ‘VIP PRIO’ appears
• Press OK
• The current selected filter option will be shown
• Press up or down a few times until the desired filtering option is shown on the display
(See above for the different filter options)
• Press OK
• If VIPFUNC1 or VIPFUNC2 is selected the numbers stored in the phonebook will apear on
the display. Select the telephone number which has to be linked with this option and press
OK
Note: Activating the room monitor function (See “6.5. ROOM MONITORING” on
page 24.) will overide the call screening function (HEAR AR). To activate the call
screening function, the room monitor function must be turned off.
7.2.7.
Programming the VIP Code
The VIP code is a 3-digit code used to operate the machine remotely (See “7.4. Remote
Operation” on page 28.).The VIP code is set to '000' by default.
• Press MENU
• Press up or down a few times until ‘TAD MENU’ appears
• Press OK
• Press up or down a few times until ‘PIN CODE’ appears
• Press OK
• Enter the current PIN code (default = ‘000’)
• Press OK
• Enter the new pin code and press OK
• Enter again the new pin for confirmation and press OK
Note: The SOS and VIP code cannot be the same because both can be entered during
OGM playback!!!
7.3. OPERATION
If a call is received and the answering machine is turned on, the answering machine will
automatically answer the call after the set number of rings.
If outgoing message 1 has been selected, after the outgoing message, a beep will be heard and
the caller can leave a message (max. 2 minutes).
If outgoing message 2 has been selected, after the beep, the line will automatically be
disconnected. The caller does not have the possibility to leave a message.
When there are messages, the amount of messages will be shown on the display. When there
are new messages, the -icon will blink on the base and the envelope -icon will appears on
the display.
Note: If, during recording, nothing is said for 8 seconds, the line will be automatically
disconnected.