Operation Manual

Cocoon 755/855 21
Cocoon 755/855
ENGLISH
‘BASE _‘ appears on the display.
Enter a number of the base unit you would like to subscribe the handset to (1-4).
Use the number keypad.
Note: Each handset can be subscribed to 4 different DECT base units. Each base
unit is assigned a number from 1 to 4 in the handset. When you subscribe a new
handset, you can assign a base unit number. It is best to use ‘1’ .
‘SEARCHING’ and the symbol appears on the display.
The RFPI code (each base unit has a unique RFPI code) appears on the display and a
signal sounds when the handset has found the base unit.
Press the Programming key .
‘PIN’ appears on the display.
Enter the 4-digit PIN code of the base unit in (default PIN code is ‘0000’). Use the number
keypad.
Press the Programming key .
The handset is subscribed to the base unit.
4.24 SUBSCRIBING COCOON 755/855 HANDSET ON ANOTHER BASE
(OTHER BRAND/MODEL)
Put the base in subscription mode (see manual of the base). If the base is in subscribing
mode, you have to do the following to subscribe the handset:
Press the Programming key .
Press the Up or Down key repeatedly until ‘BASE SUB’ appears on the display.
Press the Programming key .
‘BASE _‘ appears on the display.
Enter a number for the base unit to which you would like to subscribe the handset (1-4).
Use the number keypad.
‘SEARCHING’ and the symbol appear on the display.
The RFPI code (each base unit has a unique RFPI code) appears on the display and a
signal sounds once the base unit is found by the handset.
Press the Programming key .
‘PIN’ appears on the display.
Enter the 4-digit PIN code of the base unit (default PIN code is ‘0000’). Use the number
keypad.
Press the Programming key .
The handset is subscribed to the base unit.
4.25 REMOVING SUBSCRIPTION OF A HANDSET TO A BASE UNIT
It is possible to cancel subscription of a handset to a base unit. You would do this if a
handset is damaged and has to be replaced by a new one.
Caution: You can only cancel subscription of another handset, not the handset
you are using to do the cancellation procedure.
Press the Programming key .
Press the Up or Down key repeatedly until ‘SETTING’ appears on the display.
HL_Coc755_mideur.book Page 21 Monday, October 27, 2003 4:33 PM