Telephone User Guide

37
Deskmaster
13.9 User to User Signalling (UUS)
The ISDN phone can be programmed to automatically release a preprogrammed text message on
outgoing calls. This function allows you to send a short message to a phone without establishing a
connection. There are 5 fixed, standard texts and 1 user programmable text available.
13.9.1 Programming UUS Messages
• Idle state.
• Go to the UUS text menu.
• Select the menu.
• Select the UUS text selection
• Select the function or go the next item.
With OK, a previously selected
UUS text will be turned off.
• Scroll through the available texts
with the LEFT and RIGHT arrow keys.
Select the required text with OK.
• Scroll through the available texts
with the LEFT and RIGHT arrow keys.
Select the required text with OK.
OR • Select the required text with OK.
The selected UUS-Text is activated
• Enter your own text using the keypad.
• The selected UUS-Text is automatically
activated
13.10 Least cost routing (LCR function)
The Deskmaster can dial out special carrier prefix before the number, depending of the dialled number.
In this way you can automatically route your calls via the cheapest operator. For using the LCR function
you need to first dial the digit and then press speaker key or lift the handset. When you first press
speaker key or lift the handset and start dialling, it is impossible for the unit to add prefix number.
The required settings for the LCR function:
• Idle state
• Select the menu entry System parameters
Mo. 21 Feb 99 17:26
ISDN
320 UUS Text
UUS Text
321 OFF
UUS Text
322 UUS select text
1 : please call
back
2 : please call
back tomorrow
Mo. 21 Feb 99 17:26
ISDN
6 : User text
text?
6 : User text
Mo. 21 Feb 99 17:26
ISDN
250 System param.
HL_DM5201_GB.qxd 16-04-2003 13:24 Page 37