User Manual

HiPerII Chapter 1
Figure 2-7. Install SIM Card
Once the receiver is turned on, the receiver board will detect the SIM card, and it will be ready
to use as needed.
Charging the Batteries
To charge the battery, use the included charger. It takes approximately two hours to
completely charge one battery, and four hours to charge two batteries.
The batteries are shipped from the factory without power. Fully charge the batteries
be-fore surveying.
The Li-Ion batteries used in the battery packs should run at no less than 80% capacity after
500 charging cycles. These batteries do not need to be drained before recharging.
Power Management
This chapter describes how to power your receiver. Before using the receiver for the first time,
ensure that you have followed the setup instructions.
Powering the Receiver
HiPerII Chapter 1