User Manual

HiPerII Chapter 1
FCC Compliance
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1.This device may not cause harmful interference, and
2.This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a digital device,
pursuant to Part 15 of the FCC rules. These limits and designed to provide reasonable protection
against harmful interference in residential installations. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, There is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause interference to radio or television equipment reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Move the equipment away from the receiver.
• Plug the equipment into an outlet on a circuit different from that to which the receiver is
powered.
• Consult the dealer or an experienced radio/television technician for additional suggestions.
*CAUTION*
Any changes or modifications to the equipment not expressly approved by the party responsible
for compliance could void your authority to operate such equipment.
FCC RF Radiation Exposure Statement
To comply with FCC/IC RF exposure compliance requirements a separation distance of at least
20 cm must be maintained between the antenna of this device and all persons. This device must
not be co-located or operating in conjunction with any other antenna or transmitter.
HiPerII Chapter 1