Installation Manual
Table Of Contents
- X-22 Excavator Indicate System Installation and Calibration Manual
- Table of Contents
- Introduction
- Installation and Calibration
- Getting Started
- Step 1: Charge the Sensors
- Step 2: Attach the Brackets
- Step 3: Attach the Mast for the PitchRollCompass
- Step 4: Attach the X-22 Display
- Step 5: Measure the Excavator
- Step 6: Entering the Sensors on the X-22 Display
- Step 7: Attach the Sensors to the Excavator
- Step 8: Calibrate the Sensors
- Step 9: Measure and Calibrate the Buckets
- Finding Your Way Around the Software
- Before You Start to Dig
- Important Information On Use
- Machine and Bucket Measurements
- Getting Started
- Troubleshooting
- The X-22 Display is not responding, what should I do?
- The sensors are not responding, what should I do?
- A sensor is damaged, what should I do?
- How do I recalibrate a sensor?
- The system is not measuring accurately, what should I do?
- The compass is measuring incorrectly, what should I do?
- The laser sensor is not working, what should I do?
- Specifications
- Safety Warnings
- Regulatory Information
- Warranty Terms
- Back Cover
Installation and Calibration
P/N 7010-1019
2-5
Bracket for Arm (Stick) Sensor with Laser
Detector
The bracket for the arm (stick) sensor must be attached to the side of
the arm (stick) that faces the cab.
Position the bracket so that the sensor is roughly vertical when the
laser hits it. Take care not to attach the bracket too high on the arm
(stick) to avoid problems with getting the laser beam to hit the sensor.
Figure 2-6. Arm (Stick) Sensor Bracket Location
NOTICE
Attach the bracket for the arm sensor with the
spring clips at the top so that the sensor slides in
from above.