Installation Manual
Table Of Contents
- X-22 Excavator Indicate System Installation and Calibration Manual
- Table of Contents
- Introduction
- Installation and Calibration
- Getting Started
- Step 1: Charge the Sensors
- Step 2: Attach the Brackets
- Step 3: Attach the Mast for the PitchRollCompass
- Step 4: Attach the X-22 Display
- Step 5: Measure the Excavator
- Step 6: Entering the Sensors on the X-22 Display
- Step 7: Attach the Sensors to the Excavator
- Step 8: Calibrate the Sensors
- Step 9: Measure and Calibrate the Buckets
- Finding Your Way Around the Software
- Before You Start to Dig
- Important Information On Use
- Machine and Bucket Measurements
- Getting Started
- Troubleshooting
- The X-22 Display is not responding, what should I do?
- The sensors are not responding, what should I do?
- A sensor is damaged, what should I do?
- How do I recalibrate a sensor?
- The system is not measuring accurately, what should I do?
- The compass is measuring incorrectly, what should I do?
- The laser sensor is not working, what should I do?
- Specifications
- Safety Warnings
- Regulatory Information
- Warranty Terms
- Back Cover
X-22 Installation and Calibration Manual
2-6
Bracket for Bucket Sensor
The best place to attach the bracket for the bucket sensor depends on
the size of the excavator and if the joints are tight or loose.
It is easiest to make X-22 measure accurately if the bucket sensor is
attached directly on the bucket/quick coupler. This is especially the
case if the joints are loose.
Alternative 1: The inside of the quick coupler/bucket
If the excavator is large enough, the bracket for the bucket sensor can
be attached on the inside of the quick coupler/bucket. Attach the
bracket on the part of the quick coupler/bucket closest to the cab.
Figure 2-7. Quick Coupler/Bucket Bracket Location - Inside
NOTICE
Fully extend and retract the bucket cylinder before
fitting and make sure that the bracket and the sensor
do not meet any obstructions.