Installation Manual
Table Of Contents
- X-22 Excavator Indicate System Installation and Calibration Manual
- Table of Contents
- Introduction
- Installation and Calibration
- Getting Started
- Step 1: Charge the Sensors
- Step 2: Attach the Brackets
- Step 3: Attach the Mast for the PitchRollCompass
- Step 4: Attach the X-22 Display
- Step 5: Measure the Excavator
- Step 6: Entering the Sensors on the X-22 Display
- Step 7: Attach the Sensors to the Excavator
- Step 8: Calibrate the Sensors
- Step 9: Measure and Calibrate the Buckets
- Finding Your Way Around the Software
- Before You Start to Dig
- Important Information On Use
- Machine and Bucket Measurements
- Getting Started
- Troubleshooting
- The X-22 Display is not responding, what should I do?
- The sensors are not responding, what should I do?
- A sensor is damaged, what should I do?
- How do I recalibrate a sensor?
- The system is not measuring accurately, what should I do?
- The compass is measuring incorrectly, what should I do?
- The laser sensor is not working, what should I do?
- Specifications
- Safety Warnings
- Regulatory Information
- Warranty Terms
- Back Cover
Installation and Calibration
P/N 7010-1019
2-9
Alternative 4: The outside of the control arm (dog-bone)
If the excavator is too small to fit the bracket with the bucket sensor
on the inside of the control arm and the joints are tight, the bracket
can be attached on the outside of the control arm. Attach the bracket
on the control arm closest to the cab.
Figure 2-10. Outside of Control Arm (Dog-bone)
NOTICE
Fully extend and retract the bucket cylinder before
fitting and make sure that the sensor do not meet
any obstructions.
NOTICE
Attach the bracket with the spring clips on the left
so that the sensor slides into the bracket from the
left.