Installation Manual

Installation and Calibration
P/N 7010-1019
2-17
Step 5: Measure the Excavator
Turn the X-22 Display on and select Main menu Setup
Excavators New to enter your excavator.
Figure 2-20. Create a New Machine
Later in this manual you will find a list of the measurements you need
to take. Use it for reference and making notes while measuring. You
will find a tape measure in the case.
Step 6: Entering the Sensors on the
X-22 Display
Once the sensors are fully charged and have been taken out of the
charger, they have to be entered on the X-22 Display. Select Main
menu Setup Hardware Sensors. If the sensors have been
entered already they are listed on the screen.
Select New and enter all the sensors one by one if they are not already
entered. Entering a new sensor can take few minutes.
NOTICE
It is important to measure the excavator accurately.
If the dimensions are wrong, X-22 will not measure
as accurately as it should.