Installation Manual
Table Of Contents
- X-22 Excavator Indicate System Installation and Calibration Manual
- Table of Contents
- Introduction
- Installation and Calibration
- Getting Started
- Step 1: Charge the Sensors
- Step 2: Attach the Brackets
- Step 3: Attach the Mast for the PitchRollCompass
- Step 4: Attach the X-22 Display
- Step 5: Measure the Excavator
- Step 6: Entering the Sensors on the X-22 Display
- Step 7: Attach the Sensors to the Excavator
- Step 8: Calibrate the Sensors
- Step 9: Measure and Calibrate the Buckets
- Finding Your Way Around the Software
- Before You Start to Dig
- Important Information On Use
- Machine and Bucket Measurements
- Getting Started
- Troubleshooting
- The X-22 Display is not responding, what should I do?
- The sensors are not responding, what should I do?
- A sensor is damaged, what should I do?
- How do I recalibrate a sensor?
- The system is not measuring accurately, what should I do?
- The compass is measuring incorrectly, what should I do?
- The laser sensor is not working, what should I do?
- Specifications
- Safety Warnings
- Regulatory Information
- Warranty Terms
- Back Cover
X-22 Installation and Calibration Manual
2-30
Important Information On Use
This section describes how the equipment should be handled. If the
guidelines are not followed, there might be a risk of explosion, fire,
injury or damage to the equipment.
Charger
The charger is for indoor use only. Avoid moisture. Batteries charge
faster at lower temperatures, but the sensors must never be charged at
temperatures below 0°C (32°F).
Operating temperature 0°C to +35°C
35°F to +95°F
Not waterproof
For indoor use only
NOTICE
Never put wet sensors in the charger.
NOTICE
Make sure the contacts on the sensors and the
charger are free of debris before charging.