Installation Manual
Table Of Contents
- X-22 Excavator Indicate System Installation and Calibration Manual
- Table of Contents
- Introduction
- Installation and Calibration
- Getting Started
- Step 1: Charge the Sensors
- Step 2: Attach the Brackets
- Step 3: Attach the Mast for the PitchRollCompass
- Step 4: Attach the X-22 Display
- Step 5: Measure the Excavator
- Step 6: Entering the Sensors on the X-22 Display
- Step 7: Attach the Sensors to the Excavator
- Step 8: Calibrate the Sensors
- Step 9: Measure and Calibrate the Buckets
- Finding Your Way Around the Software
- Before You Start to Dig
- Important Information On Use
- Machine and Bucket Measurements
- Getting Started
- Troubleshooting
- The X-22 Display is not responding, what should I do?
- The sensors are not responding, what should I do?
- A sensor is damaged, what should I do?
- How do I recalibrate a sensor?
- The system is not measuring accurately, what should I do?
- The compass is measuring incorrectly, what should I do?
- The laser sensor is not working, what should I do?
- Specifications
- Safety Warnings
- Regulatory Information
- Warranty Terms
- Back Cover
X-22 Installation and Calibration Manual
2-32
X-22 Display and Power Supply
The kit contains a power cable for the X-22 Display with a cigarette
lighter plug, which can be used for both 12V and 24V supply.
Machine and Bucket
Measurements
On the next several pages there are pictures illustrating all excavator
and bucket measurements that must be taken. Refer to these pictures
and make a note of the dimensions beside them while taking the
measurements.
You will find more pictures showing each measurement in greater
detail on the X-22 Display, if you press Details as shown in
Figure 2-28 on page 2-33. We recommend looking through the
pictures on the X-22 Display first and familiarizing yourself with the
various measurements before starting to measure.
Operating temperature 0°C to +50°C
35°F to +122
Storage temperature -20°C to +70°C
35°F to +158°F
Not waterproof