Installation Manual
Table Of Contents
- X-22 Excavator Indicate System Installation and Calibration Manual
- Table of Contents
- Introduction
- Installation and Calibration
- Getting Started
- Step 1: Charge the Sensors
- Step 2: Attach the Brackets
- Step 3: Attach the Mast for the PitchRollCompass
- Step 4: Attach the X-22 Display
- Step 5: Measure the Excavator
- Step 6: Entering the Sensors on the X-22 Display
- Step 7: Attach the Sensors to the Excavator
- Step 8: Calibrate the Sensors
- Step 9: Measure and Calibrate the Buckets
- Finding Your Way Around the Software
- Before You Start to Dig
- Important Information On Use
- Machine and Bucket Measurements
- Getting Started
- Troubleshooting
- The X-22 Display is not responding, what should I do?
- The sensors are not responding, what should I do?
- A sensor is damaged, what should I do?
- How do I recalibrate a sensor?
- The system is not measuring accurately, what should I do?
- The compass is measuring incorrectly, what should I do?
- The laser sensor is not working, what should I do?
- Specifications
- Safety Warnings
- Regulatory Information
- Warranty Terms
- Back Cover
X-22 Installation and Calibration Manual
A-2
X-22 Display
The following section provides specifications for the X-22 Fanless
8.9” WSVGA TFT Multifunctional Touch Panel PC.
Table A-2. X-22 Sensor General Specifications
Display Screen
LCD Size 8.9”
Display Type WSVGA TFT
Resolution 1024 x 600
Color 256K
Pixel Pitch 0.1905mm (H) x 0.189mm (V)
Luminance 220cd/m²
Contrast Ratio 500
Viewing Angle 50 (U), 60 (D), 70 (L), 70 (R)
Response Time 30ms
Backlight LED
Touch Screen 5-Wire Resistive
Light transmission 80%
Touch Interface USB Onboard Touch Interface
System
CPU Onboard AMD Geode LX800 @ 0.9W 500MHz with
128K L2 Cache CPU
Cooling Method Passive CPU Heatsink
System Chipset AMD Geode LX800/ CS5536
System Memory Onboard 512MB DDR Memory
SSD One CF Socket by IDE Secondary Slave Channel
Supports Type I/II Compact Flash Card