User's Manual
Table Of Contents
- GMS-2 Operator’s Manual
- Table of Contents
- Preface
- Ch1: Introduction
- Ch2: Preparing the GMS-2 for Use
- Ch3: Using the GMS-2
- Ch4: Troubleshooting
- ApA: GMS-2 Software Reference
- ApB: Specifications
- ApC: Safety Warnings
- ApD: Regulatory Information
- APE: Warranty Terms
- Index
Powering the GMS-2
P/N 7010-0752
2-3
To charge the battery using the optional charger, (Figure 2-3)
remove the battery from the GMS-2 (see “Installing the Battery” on
page 2-4 for details) and slide it onto the charger. Plug the charger in
to a grounded outlet.
Figure 2-3. Charging the Battery in the Charger
Charging and Battery Storage Notes
Keep the following in mind for proper charging, maintenance, and
storage of the battery.
• Only recharge the battery at room temperature, approximately
50°F to 104°F (10°C to 40°C). Charging at a high temperature
will increase the time it takes to charge the battery.
• The battery will discharge during storage. Always check the
battery charge before using the GMS-2.
• Charge a stored battery every 7 days. Allowing a battery to
become discharged can reduce the overall performance of the
battery and charge efficiency.
• The charger may become somewhat heated while charging the
GMS-2.
To Grounded
Outlet