User's Manual

Connecting the GMS-2 with Other Devices
P/N 7010-0752
3-5
6. To close BTManager but remain connected to the internal GMS-2
Bluetooth module, select “Exit on connect”.
This allows other programs to open and use the port for
communicating with other Bluetooth-enabled devices.
7. Once the Devices list has been populated, select the device to
connect to and tap Connect (Figure 3-6).
Figure 3-6. View Devices and Connect
Once a connection has been established, the Bluetooth Indicator turns
green (Figure 3-7 on page 3-6).
• If a connection takes more than two minutes, tap Reset on the
Accessibility tab. Then try connecting to the device again.
• To view information on the connected device, double-tap the
device (Figure 3-7 on page 3-6).
• Selecting/deselecting “Master mode” will switch between Master
mode and Slave mode while connected.
• To disconnect from the device, tap Disconnect.
NOTICE
If “Exit on connect” is unchecked and BTManager
is closed, BTManager and the Bluetooth module
will remain connected, but the port used for
communication will be disconnected from the
module.
Other programs will not be able to use this port for
communicating with Bluetooth-enable devices.
6
7